Name: Full Rack Colocation in Equinix DC10 Ashburn
Price: 1541 USD
Availability: InStock

Full Rack Colocation in Equinix DC10 Ashburn

Equinix campus in Ashburn, Virginia is the most interconnected location in US and an ideal choice to serve content to East Coast consumers.

Location

Power

Power Lines

	SETUP	MONTHLY
2 x 30A / 208V redundant power lines – Each line is sourced from a different UPS and has its own circuit breaker that triggers when the line 30A rating is reached. – Power lines are installed close enough to rack cabinet to allow PDUs to be connected with their own cable. The PDUs, ideally, should have the same Voltage and Amperage rating as the lines. If they don’t, they must be equipped with circuit breakers from the factory. – Each power line has a single NEMA L6-30R receptacle (requires NEMA L6-30P plug) that allows to connect one PDU per line. – Equipment installed in rack cabinet ideally would have two power sources, each one connected to a different power line to achieve power redundancy. – Equipment with one power source should be connected balanced between power lines and they will not be protected against one line power failures.	-	-
2 x 3-phase 50A / 208V redundant power lines – Each line is sourced from a different UPS and has its own circuit breaker that triggers when the line reaches its 50A rating. – Power lines are installed close enough to the rack cabinet to allow PDUs to be connected with their own cables. Ideally, the PDUs should have the same voltage and amperage rating as the lines. If they don't, they must be equipped with factory-installed circuit breakers. – Each power line has a single CS8369 receptacle, allowing one PDU to be connected per line. – Ideally, equipment installed in the rack cabinet should have two power sources, each connected to a different power line to achieve power redundancy. – Equipment with only one power source should be connected in a balanced manner between the power lines and it will not be protected against failures in one power line.	-	+$50.00

Power Consumption

	SETUP	MONTHLY
3 kVA maximum power draw from all power lines in a Equinix US Datacenter – Or 14.4A @ 208V or 2190 kWh/month Power plan can be upgraded and we will notify you if the draw is higher than the one contracted (Each additional 0,1 kVA power draw above 3 kVA included is charged with an excessive usage fee of: $114.00/0,1 kVA)	-	-
4 kVA committed power draw from all power lines installed in full rack cabinet - A power draw of 4 kVA is approximately equal to a current of 19.2A at 208V, 18.2A at 220V or 17.4A at 230V, resulting in a power consumption of 2880 kWh per month. This is equivalent to using 8230 watts of primary server sources at 35% capacity - Going above the committed power draw may result in excessive usage fees until this power consumption plan is upgraded (Each additional 0,1 kVA power draw above 4 kVA included is charged with an excessive usage fee of: $102.00/0,1 kVA)	-	+$128.00
5 kVA maximum power draw from all power lines installed in full rack cabinet - A power draw of 5 kVA is approximately equal to a current of 24A at 208V, 22.7A at 220V or 21.7A at 230V, resulting in a power consumption of 3600 kWh per month. This is equivalent to using 10285 watts of primary server sources at 35% capacity - Even if each power line or all power lines combined can support a higher power draw, the data center does not allow it due to several reasons: a) the UPS provisioned capacity cannot handle a higher power draw, b) there would be a loss of redundancy in case load moves to a single line due to one line power failure, c) the cooling provisioned capacity for this rack cabinet would be exceeded - Going above the power draw threshold can put you at risk of power disconnection - It is recommended to draw almost the entire power allowed under normal usage conditions and configure the equipment to start randomly at power-up. This will avoid power-on spikes that might trigger the circuit breakers (Each additional 0,1 kVA power draw above 5 kVA included is charged with an excessive usage fee of: $102.00/0,1 kVA)	-	+$488.00

Colocation Support

SLA for Colocation

	SETUP	MONTHLY
Standard SLA for a Colocation service. 'Remote hands' This SLA assumes the equipment is installed by customer and works well, no hardware changes are expected and only occasional simple emergency requests might be required. Standard SLA includes unlimited number of requests for power cycles, visual inspection of equipment, access to a shared remote KVM along with very simple tasks for hot-plug components or cables like 'plug / unplug' or 'take .. from .. and replace .. '. The SLA does not cover installation/removal/replacement of non-hot plug components or any hardware or software troubleshooting. Requests under this SLA are executed first come, first served by 24/7 on-site datacenter personnel under the assumption they are 'urgent'. Under normal operation conditions such requests are executed in less than 30 minutes, but no guarantee is provided. (On-site support not included in Standard SLA is charged: $52.00/Hour)	-	-
Expert SLA for a Colocation service. 'Remote Hands and Expert Installation' This SLA covers two batches of equipment physical installation in rack cabinet at a agreed date and later, packaging and shipping. Cost of packaging material, shipping and import/export duties are charged separately. It also covers expert cabling of Internet, private, management and out-of-band networks and the cost of all UTP cables and patches. It doesn't cover fiber and twinaxl patches that must be purchased separately. The Expert SLA includes software configuration of ILO / DRAC / IMM management ports and troubleshooting to power up the equipment. The post-install maintenance includes unlimited number of requests for power cycles, visual inspection of equipment, access to a shared remote KVM along with very simple tasks for hot-plug components or cables like 'plug / unplug' or 'take .. from .. and replace .. '. The SLA does not cover installation/removal/replacement of non-hot plug components or any troubleshooting outside the two initial installation/removal batches. Maintenance requests under this SLA are prioritized over Standard SLA and executed first come, first served by 24/7 on-site datacenter personnel under the assumption they are 'urgent'. Under normal operation conditions such requests are executed in less than 30 minutes, but no guarantee is provided. (On-site support not included in Expert SLA is charged: $52.00/Hour)	+$624.00	-

Connectivity

Cross Connects Patch Panel

Fiber Connectivity

	SETUP	MONTHLY
Fiber Patch Panel with 24 single mode fiber pairs (SC) in Equinix US	-	-

Full Rack Colocation in Equinix DC10 Ashburn

Product Specifications

Location

Power

Power Lines

Power Consumption

Colocation Support

SLA for Colocation

Connectivity

Cross Connects Patch Panel

Fiber Connectivity

Choose from available quotes linked to this account

Step 1. Page format

Step 2. Offer content

Full Rack Colocation in Equinix DC10 Ashburn

Product Specifications

Location

Power

Power Lines

Power Consumption

Colocation Support

SLA for Colocation

Connectivity

Cross Connects Patch Panel

Fiber Connectivity

Add to Quote

Choose from available quotes linked to this account

Export This Offer

Step 1. Page format

Step 2. Offer content